Categories
Contact Us

DYS BEARINGS

 

Add: No.555 East Luqiao Ave Luqiao District, Taizhou City, Zhejiang

Tel: 0086 (576) 8247 9090(4L)

Fax: 0086 (576) 8241 2588

E-mail: info@dysmail.com

For more details, please visit www.dys.com.cn

For more new products, please visit www.mydys.com

CD:www.dys.cn/CD

QQ: 2621206306


WhatsApp:

Ms.Amy: 135 8605 0666

Ms.Terry: 135 5868 8953

Ms.Cintita: 136 0576 5569

Service Hotline
+86-576-82479090

News

Home > NewsContent

Related Knowledge Of Bearing Installation

DYS BEARINGS | Updated: May 17, 2017

1. Cleaning work before installation: bearings in the bearing housings, bearing housings and bearings between the operating space must be kept clean, otherwise the bearing rolling surface prone to scratch and point corrosion; before installing the bearing seat, it must be cleaned inside the housing.


2. Sealing test of bearing housings: Bearing housings are many double sealed bearing housings, sealing performance is very critical, so the sealing ring must be installed compact, no seal gaps, otherwise prone to early bearing damage. Insert half of the double lip seal into the sealing groove on both sides of the pedestal. The space between the seal two lips fills the grease. If the housings are used for shaft ends, insert end caps on one side instead of seals.


3. Mounting holes and their fixing stations: the mounting holes are standard before mounting, whether the installation holes correspond to the fixing holes, whether the fixed degree of the mounting housing is standard, and the above data will be tested before installing.


4. Inspect the surface roughness of the support surface. If the bearing is mounted on the fastening sleeve, the orientation of the bearing seat is determined. The nozzle position of the top cover of the housing should always be on the other side of the fastening sleeve nut. You must pay attention to the direction of the entire bearing seat, because the top cover and the base shall be mounted in the original direction. Determine the direction of the bearing seat on the supporting surface. Mount the anchor Bolt but don't tighten it.